Results 1 to 8 of 8

Thread: 5 Mins with a Multi-meter

  1. #1
    Senior Member matespace's Avatar
    Join Date
    Aug 2019
    Posts
    737



    Things to remember:

    1. Multimeter must be in DC mode.
    2. Place red lead on positive post, black lead on negative post
    3. Note the voltage and compare to Odyssey Charging Chart
    4. Red lead must be plugged into the volt side (as per the pic)

    Voltmeter Reading State of Charge
    12.84 Volts or higher 100%
    12.50 Volts 75%
    12.18 Volts 50%
    11.88 Volts 25%

    4. If the voltage is below 12.6 then the user should give the battery a top up charge and check the voltage of the alternator. This would apply if the car is driven often as the alternator should be enough to keep the battery charged. If the car is driven very infrequently, customer needs to check for parasitic loads or other causes for the lower voltage.

    5. Check the alternator by turning the car on and placing the leads on the battery and the voltage should be a minimum of 13.8VDC. If the voltage is below 13.8VDC then the alternator is not putting enough voltage on the battery to keep it charged and would need to be looked at by a qualified technician.

    6. Odyssey batteries all come with an owner?s manual in the box and it is highly recommended that customers keep this manual as it has a lot of useful information in relation to the battery.



  2. #2
    Guest
    If, after five minutes you still haven't worked out why your test isn't working...

    FWIW, (I'm sure it's just a generic picture but...) the picture shows the red lead plugged into the Amps side of the meter.

    This won't work for the test detailed.

    It needs to be in the Volts side.

  3. #3
    Senior Member matespace's Avatar
    Join Date
    Aug 2019
    Posts
    737
    thanks for pointing that out .

    fixed





  4. #4
    Senior Member Wattens's Avatar
    Join Date
    Aug 2019
    Posts
    5,257
    That is one clean R32 boot

  5. #5
    Guest
    Quote Originally Posted by g2s View Post
    thanks for pointing that out .

    fixed
    no worries, bit not quite fixed :tilt:

    now you have the multi meter function set to "temp", but you don't have a thermocouple connected!

    I'm just saying............

  6. #6
    Administrator mondi's Avatar
    Join Date
    Aug 2019
    Posts
    20,087

  7. #7
    Guest
    I'm just saying................... :tilt:

    right is right, wrong is wrong.

    Tools are tools, and tools that use tools wrong, are even bigger tools.

  8. #8
    Administrator mondi's Avatar
    Join Date
    Aug 2019
    Posts
    20,087
    No idea what you are on about..........



Thread Information

Users Browsing this Thread

There are currently 5 users browsing this thread. (0 members and 5 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •